How to install servo hydraulic press

The installation of servo hydraulic press, which may become a worry for many people, many people do not understand how to install the servo hydraulic press, if the installation is not good, this problem is a very serious problem, there may be safety problems, and safety issues are crucial, so the installation of the machine is particularly important;

The installation method of the servo hydraulic press is: first of all, the press is placed on the cement foundation, and the level is tested on the left and right of the fuselage workbench. The levelness is required to allow 0.20 mm per 1000 mm length. If there is uneven material iron, adjust it until it meets the requirements. Then after the cement sets, the anchor screw manager (M24) should be evenly tightened, and the levelness of the fuselage table should be checked with a level. Special attention should be paid to the press that the foundation must be completely solidified before it can start working. After the press is installed, it should be installed with a reliable grounding line, and carefully wash the rust oil on the press processing surface with kerosene, do not fall on the paint surface, so as not to damage the paint, should be careful to clean the shoulders and depressions, dry with cotton yarn after cleaning, coated with a thin layer of lubricating oil, and check whether the lubrication holes are smooth, not blocked.

Generally speaking, as long as the installation work is carried out according to the installation instructions, the problem will not be very big, but it should be noted that it is not just to install it, pay attention to maintenance and maintenance, which is also very important and can not be ignored.