Hot press use method and precautions

When using a hot press, the following steps and precautions should be followed:

1. Before operation: Ensure the safety of the hot press and its surrounding environment, check the status of switches, and ensure that the power supply is correctly connected. Set the appropriate temperature and pressure according to the product requirements.

2. Operation process:

Follow the set procedure, including heating, pressure, pressure maintenance and pressure relief steps.

During operation, avoid direct contact with the upper and lower electrodes of the hot press to prevent short circuit or burn.

Keep the oil switch on to reduce wear between parts.

Monitor the hydraulic oil temperature, use the cooler if necessary, and select the appropriate hydraulic oil viscosity according to the season.

Ensure mold and workpiece are properly aligned on the active surface to avoid bias.

Keep the press clean and evenly stressed, and remove the residue on the surface of the template in time to avoid affecting the quality of the finished product.

3. Safety precautions:

During operation or maintenance, do not put your hand into the hot press plate to prevent squeezing injury.

In a thunderstorm, stop the machine and cut off the power supply in time.

Non-professionals are not allowed to adjust the hydraulic oil road relief valve, electrical circuit part or change the conveyor belt running speed and other parameters.

When abnormal sound or fault is found, the machine should be stopped immediately for inspection to ensure that the machine does not work with disease.

4. Maintenance and maintenance: When not in use for a long time, the equipment should be cleaned and placed in a dry place.

Following these steps and precautions can ensure the safe and efficient operation of the hot press while extending the service life of the equipment.